Real-time ultrasonic diagnosis of polymer degradation and filling incompleteness in micromoulding.
Whiteside, Benjamin R. Ono, Y. Jen, C.K. Coates, Philip D.
Whiteside, Benjamin R.
Ono, Y.
Jen, C.K.
Coates, Philip D.
Publication Date
2005
End of Embargo
Supervisor
Rights
Peer-Reviewed
Yes
Open Access status
closedAccess
Accepted for publication
Institution
Department
Awarded
Embargo end date
Additional title
Abstract
Injection moulding techniques have been miniaturised and refined to achieve micromoulding which aims to satisfy the need for mass production of low-cost micro- and nanoscale components. However, the microscale mould cavity features and extreme processing conditions which are inherent in the process can result in larger process variations than conventional injection moulding, with a corresponding increase in the probability of producing an unsatisfactory product. Accurate process diagnosis is required to ensure process reliability but integration of sensors onto the small and highly detailed mould units can be problematic and alternatives may need to be sought. Piezoelectric film ultrasonic transducers were integrated onto the extrusion barrel and mould insert of a micromoulding machine for real-time, non-destructive and non-intrusive process diagnosis with an ultrasonic pulse-echo technique. Polymer degradation owing to excessive heating at the extrusion barrel was successfully probed by measuring the ultrasonic velocities in the polymer at the mould insert. Filling incompleteness of the mould cavity was also sensitively detected by monitoring the ultrasonic energy variation transmitted into the part at different points along the melt flow length. The developed ultrasonic sensors and technique enable optimisation and in-process quality assurance of the moulded parts which ensures that maximum process efficiency can be achieved.
Version
No full-text in the repository
Citation
Whiteside, B.R., Brown, E.C., Ono, Y., Jen, C.K. and Coates, P.D. (2005). Real-time ultrasonic diagnosis of polymer degradation and filling incompleteness in micromoulding. Plastics Rubber and Composites. Vol. 34, No. 9, pp. 387-392.
Link to publisher’s version
Link to published version
Link to Version of Record
Type
Article