Publication

Tailoring mechanical properties and microstructure of stainless steel wires-modified ultra-high performance concrete via direct electric curing

Dong, S.
Ouyang, X.
Ding, S.
Han, B.
Publication Date
2025-06
End of Embargo
Supervisor
Rights
(c) 2025 Elsevier. Reproduced in accordance with the publisher's self-archiving policy. This manuscript version is made available under the CC-BY-NC-ND 4.0 license (http://creativecommons.org/licenses/by-nc-nd/4.0/)
Peer-Reviewed
Yes
Open Access status
embargoedAccess
Accepted for publication
2025-04-19
Institution
Department
Awarded
Embargo end date
2027-04-25
Additional title
Abstract
This study investigates the influence of direct electric curing with various durations on thermal, mechanical properties and microstructure of stainless steel wires (SSWs) modified ultra-high performance concrete (UHPC), meanwhile, the energy consumption and carbon emission were compared to verify the supplementary effectiveness of SSWs for incomplete network of commonly used steel fibers (SFs). 0.2 vol% SSWs with micro diameter clearly stabilizes the electrical resistivity of UHPC and enables temperature ascending rate of UHPC reach 0.7-0.9 °C/min by Joule effect. 8 h/12 h-20 W direct current electric curing with surface temperature of 70 - 80 °C results in compressive strength of 120.3 MPa /130.7 MPa, and flexural strength of 18.7 MPa/18.2 MPa, respectively, for UHPC modified with 0.2 vol% SSWs and 1.6 vol% SFs (S02F16), accounting for 80.8%/87.8% and 78.6%/76.5% of compressive and flexural strength of composites achieved with 28 d-standard curing. The compressive strength of composites typically increases with prolonged electric curing. However, the flexural strength demonstrates decreasing trend when the duration exceeds 8 h. The flexural failure strain, absorbed energy before the occurrence of macrocracks, and multiple cracking failure characteristic of 8 h-electric curing S02F16 preserved to 28 d are significantly enhanced, resulting from the refined pore structure, coarsened SSWs’ interfaces, and enhanced SFs’ interfaces under the coupling effect of elevated temperature and direct electric current, confirming an innovative finding of reinforcing effect of SSWs-controlled conductive pathway on SFs’ interface and matrix’s microstructure. Energy consumption/carbon emission for per MPa/per-increasing MPa compressive strength of electric curing is 23.2%/36.5% and 14.6%/23.8% less than that of hot water curing for S02F16 and S04F16. Furthermore, taking advantage of SSWs’ micro diameter and superior conductivity, electric curing on UHPC has potential to be carried out with green and new energy sources to further reduce carbon footprint especially for low temperature environment construction.
Version
Accepted manuscript
Citation
Dong S, Ouyang X, Ding S et al (2025) Tailoring mechanical properties and microstructure of stainless steel wires-modified ultra-high performance concrete via direct electric curing. Construction and Building Materials. 479: 141425.
Link to publisher’s version
Link to published version
Type
Article
Qualification name
Notes
The full-text of this article will be released for public view at the end of the publisher embargo on 25 April 2027.