Loading...
The flow of lubricant as a mist in the piston assembly and crankcase of a fired gasoline engine
Dyson, C.J. Lee, P.M.
Dyson, C.J.
Lee, P.M.
Publication Date
2023
End of Embargo
Supervisor
Rights
© The Author(s) 2022. Open Access. This article is licensed under a Creative Commons Attribution 4.0 International License, which permits use, sharing, adaptation, distribution and reproduction in any medium or format, as long as you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons licence, and indicate if changes were made. The images or other third party material in this article are included in the article's Creative Commons licence, unless indicated otherwise in a credit line to the material. If material is not included in the article's Creative Commons licence and your intended use is not permitted by statutory regulation or exceeds the permitted use, you will need to obtain permission directly from the copyright holder. To view a copy of this licence, visit http://creativecommons.org/licenses/by/4.0/.
Peer-Reviewed
Yes
Open Access status
openAccess
Accepted for publication
2022-12-02
Institution
Department
Awarded
Embargo end date
Additional title
Abstract
The tribological performance of the piston assembly of an automotive engine is highly influenced by the complex flow mechanisms that supply lubricant to the upper piston rings. As well as affecting friction and wear, the oil consumption and emissions of the engine are strongly influenced by these mechanisms. There is a significant body of work that seeks to model these flows effectively. However, these models are not able to fully describe the flow of lubricant through the piston assembly. Some experimental studies indicate that droplets of lubricant carried in the gas flows through the piston assembly may account for some of this. This work describes an investigation into the nature of lubricant misting in a fired gasoline engine. Previous work in a laboratory simulator showed that the tendency of a lubricant to form mist is dependent on the viscosity of the lubricant and the type and concentration of viscosity modifier. The higher surface area-to-volume ratio of the lubricant if more droplets are formed or if the droplets are smaller is hypothesised to increase the degradation rate of the lubricant. The key work in the investigation was to measure the size distribution of the droplets in the crankcase of a fired gasoline engine. Droplets were extracted from the crankcase and passed through a laser diffraction particle sizer. Three characteristic droplet size ranges were observed: Spray sized (250–1000 μm); Major mist (30–250 μm); and Minor mist (0.1–30 μm). Higher base oil viscosity tended to reduce the proportion of mist-sized droplets. The viscoelasticity contributed by a polymeric viscosity modifier reduced the proportion of mist droplets, especially at high load.
Version
Published version
Citation
Dyson CJ, Priest M and Lee PM (2023) The flow of lubricant as a mist in the piston assembly and crankcase of a fired gasoline engine. Tribology Letters. 71: Article 12.
Link to publisher’s version
Link to published version
Link to Version of Record
Type
Article