Influence of coextrusion die channel height on interfacial instability of low density polyethylene melt flow
Martyn, Michael T. Coates, Philip D. Zatloukal, M.
Martyn, Michael T.
Coates, Philip D.
Zatloukal, M.
Publication Date
2014
End of Embargo
Supervisor
Rights
Peer-Reviewed
Yes
Open Access status
Accepted for publication
Institution
Department
Awarded
Embargo end date
Additional title
Abstract
The effect of side stream channel height on flow stability in 30 degrees coextrusion geometries was investigated. The studies were conducted on a Dow LD150R low density polyethylene melt using a single extruder to feed a flow cell in which the delivered melt stream was split before, and rejoined after, a divider plate in a slit die. Wave type interfacial instability occurred at critical stream thickness ratios. Reducing the side stream channel height broadened the layer ratio operating range before the onset of interfacial instability, therefore improving process stability. Stress fields were quantified and used to validate principal stress differences of numerically modelled flow. Stress field features promoting interfacial instability in each of the die geometries were identified. Interfacial instability resulted when the stress gradient across the interface was asymmetric and accompanied by a non-monotonic decay in the stress along the interface from its inception.
Version
No full-text in the repository
Citation
Martyn MT, Coates PD and Zatloukal M (2014) Influence of coextrusion die channel height on interfacial instability of low density polyethylene melt flow. Plastics Rubber and Composites. 43(1): 25-31.
Link to publisher’s version
Link to published version
Link to Version of Record
Type
Article